2016 350M Garage floor

[RoadRunner]

Beginning to do some research to determine a good restraint system to haul a couple Harleys in my garage. I was wondering if anyone knows off hand what the floor material is and the thickness? Also, feel free to give suggestions if you have experience with a particular system you like..Currently I am beginning to like the B & W Biker Bar (https://www.youtube.com/watch?v=1VKc_w0R9_I) but not dead set on anything just yet. Thanks

[Girlfrn]

Following. We have a Harley and a can am spyder.

[RoadRunner]

I don't keep the 350 on sight or I may be able to answer my own questions about this.. However, I scheme up my next task to tackle and the questions arise! Otherwise I'd just run out into the driveway or Rv pad and crawl around under it, ha ha.. Some concerns/questions, is the aft BR holding tank below the garage floor? What the floor beams centered on, 16, 18, 24 inch? Is there the same enclose/cover below the floor as the rest of the trailer, ect.. Anyway, I appreciate any input anyone may have regarding the subject!

[Big Mike]

The floor is 1" plywood(at least it is in my 385). I too haul two bikes, via e-track and condor chocks. The only issue I have had was with one of the factory tie downs breaking(not pulling out of the frame).

Big Mike

[RoadRunner]

Thanks Big Mike

And Wow, never thought that could happen..Think I'm liking the B&W Biker Bar pretty well now!

[roadkingfl]

I have a 2012 Roadglide and a 350M...I use the biker bar.

[RoadRunner]

Nice. .was the bar easily installed or difficult?

[Girlfrn]

We watched a you tube video and it sure looked easy to use.

[roadkingfl]

Takes a minute...

[RoadRunner]

Only a minute? Sarcasm or serious? ..I was out to my trailer this weekend and crawled under for a look. .did you drop the fuel tank to install the base unit? Any help is appreciated