2016 348 m hydraulics not working! Need help!

[Brentalive]

So I have a 2016 348 m Ive had for about 8 months and I just got home with it from a trip and everything was working great!
When I started unloading at home I heard the hydraulics try working on and off it sounded like it was trying to retract the hydraulics but they were already all up so it would go on for 5 seconds then turn off for 5 seconds and keep repeating until I quickly hit the battery disconnect than it stopped! So I went to the lippert control and it says error and press enter to acknowledge so I did but nothing works now and when I pressed the right jack to extend the jack, majically the main slide out started to go in! What the heck I thought thats not right! So I went inside the trailer and tryed the main slide out button and it does nothing now!

So I just left everything now and am going to call the dealer in the morning to see if they can look at it but my slides are not able to slide in so is there a manual way of getting my slides in?
Or has anybody encountered this before and maybe knows what going on?

Also I did not have it plugged when this all occured it happened right when I got home and extended the slides to start unloading!
Any help would be great! Thanks!

[RickTulsa]

Pull the fuse to the controller and let it sit for an extended period so it will drain any parasitic power. Then reinsert the fuse and see if all goes back to normal. (Some have let it sit for up to 24 hrs)

[Brentalive]

Ok I will give it a try thanks !

[Brentalive]

So pulled the fuse and let sit for couple hrs and then tryed slide again and now it works but the rear jacks are the only thing not working now, the fronts work fine! On control for jacks the rear jack light keeps flashing! Any way of figuring out to fix the rear jacks?

[geb339]

Just had a similar problem, No display at the ground level control panel, but the rear and left light was blinking on the control panel,and the front jacks would operate.
GD thought it was a bad battery but it tested perfect, after having it tested and placing the battery back in service everything fired up normally.
You may want to disconnect the battery completely. All this happened while I was on shore power.
Best of Luck!!

[Brentalive]

Just had a similar problem, No display at the ground level control panel, but the rear and left light was blinking on the control panel,and the front jacks would operate.
GD thought it was a bad battery but it tested perfect, after having it tested and placing the battery back in service everything fired up normally.
You may want to disconnect the battery completely. All this happened while I was on shore power.
Best of Luck!!

Thanks yes I just disconnected all power and now everything is working as it should! Weird I hope it doesnt happen again !

[RickTulsa]

Check your grounds. Make sure that they are tight.

[el Rojo]

Glad you're up and running. Rick has a good idea though.

[Brentalive]

Check your grounds. Make sure that they are tight.

thanks will do!!