User Tag List
Thanks: 0
Likes: 0
Results 1 to 3 of 3
-
09-19-2016, 12:14 PM #1
- Join Date
- Nov 2015
- Location
- Simpsonville, South Carolina
- Posts
- 293
- Mentioned
- 7 Post(s)
- Tagged
- 0 Thread(s)
Schwintek Slide Out Motor Controller Question
The controller has 2 motor outputs and will keep them in sync. Does one motor follow another (master / slave) or does one speed up and another one slow down? And is the position encoder output pulsed? How many pulses per rev? Trying to educate myself a little. Haven't been able to find much other than basic info. Thanks!
Steven and Linda Akers
-
09-20-2016, 04:52 AM #2
- Join Date
- May 2016
- Location
- Round Rock, TX
- Posts
- 354
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I know the words, don't consider me an expert, despite Googling "Schwentek slide motor" on more than one occasion!
The systems use a Hall effect sensor, to keep the motors synchronized. To help prevent issues, it is recommended you run these slides all the way in or out when operating, don't start, stop or run partially and then back. Also, once the slide has moved all the way in or out, it is recommended to keep the button / toggle switch depressed for about 3 seconds as this helps to maintain the synchronization.
Hope this helps!
Tom2013 Silverado 3500HD / LWB / 2WD / Duramax-Allison
2017 Reflection 303RLS
-
09-20-2016, 07:22 AM #3
- Join Date
- May 2015
- Posts
- 1,888
- Mentioned
- 5 Post(s)
- Tagged
- 0 Thread(s)
Similar Threads
-
Schwintek Slide Controller for Grand Design Imagine 2800bh
By Knguyen525 in forum General Tech TopicsReplies: 1Last Post: 01-27-2017, 06:43 AM -
schwintek controller ....controllers
By Guns338 in forum General DiscussionReplies: 4Last Post: 12-15-2016, 02:53 PM -
Schwintek In-Wall Slide System dual motor slide controller
By LBnM in forum Electrical System and WiringReplies: 5Last Post: 02-10-2014, 11:27 AM
What changed for the new GD...
Today, 02:39 PM in General Discussion