Waste valve sizes

[Canyonlight]

Dan, now I have to cut the cloroplast to get to the black and grey bath valves to change them out. Any recommendations, and is the flex mend tape the best to seal it back up with?

Mark, I have no personal experience using any tape on our coroplast. Over the years a number of options have been shared including Gorilla tape, mobile home belly repair tape (Rob @Second Chance) used this along with other folks as I recall, and Flex Tape recommended by Megan from Customer Service at GDRV.

The dealer where our GDRV was sold shared that he would get tape to me if I ever needed any but I never pursued what product it was. Along this line, maybe you want to contact your dealer or other GDRV dealers and possibly GDRV Customer Service to solicit other feedback. Never hurts to get a number of folks share feedback.

Hopefully Rob will chime in as well as other folks who have experience with various tapes.

Dan

[MccNeo]

I have a 373FB Solitude with two black tanks and two gray tanks. I recently took a section of our coroplast down by removing the screws at the frame rails and a retainer metal strip. It allowed folding back a section of coroplast that was about 8ft x 6 ft exposing my rear gray tank and the associated discharge valve. I didn't need any tape to put it all back together. When I was done, i simply put the ccoroplast back in place and put the screws back in. I finished by spraying expanding foam in a few very minor gaps.

No tape needed.

[Old dawg]

Does anyone have a diagram showing where to find or cut thru coroplast, to service the valves without removing all coroplast on a375 ?


Sent from my iPad using Tapatalk