What did you do to your Grand Design today?

[mkevinmarshsr]

I added 2 shelves to the bedside closets. Trying to make that area a little more useful as we don't hang close up when camping.

[Cannon07]

I added 2 shelves to the bedside closets. Trying to make that area a little more useful as we don't hang close up when camping.

How do you get by without hanging clothes. My wife complains because she can't hang them when were on the motorcycle.

[EddieK82]

Drilled two holes in the back desk to make for better wire management. Now all the wires run through the holes over to the fridge side of the desk where the outlets are.

[MoonShadow_1911]

Drilled two holes in the back desk to make for better wire management. Now all the wires run through the holes over to the fridge side of the desk where the outlets are.

Two holes! Wow!

[EddieK82]

Two holes! Wow!

LoL, yep, a whole TWO holes. Here's an image. One hole on the right to feed wires down from the right side of the desk, and one hole on the left to feed the power strip under the desk where all the wires plug in. You can't see the left hole as it's behind the weekend vibes thing.

[MoonShadow_1911]

LoL, yep, a whole TWO holes. Here's an image. One hole on the right to feed wires down from the right side of the desk, and one hole on the left to feed the power strip under the desk where all the wires plug in. You can't see the left hole as it's behind the weekend vibes thing.

By all your questions, I was sure you were scared to drill just one hole, but two? Looks like you did an outstanding job! Nice work.

[MoonShadow_1911]

LoL, yep, a whole TWO holes. Here's an image. One hole on the right to feed wires down from the right side of the desk, and one hole on the left to feed the power strip under the desk where all the wires plug in. You can't see the left hole as it's behind the weekend vibes thing.

Next, you need to get rid of Windows and come over to Linux!

[EddieK82]

Next, you need to get rid of Windows and come over to Linux!

I do too much work with programs that rely on Windows, Or I would. I may install Linux side by side Windows so I can pick what one to boot into during startup, just haven't had the motivation to. My next thing is going to drilling a 2" diameter hole in the roof, I didn't realize how big that would be until the pvc got here that will go into the hole and work as a port to the inside. I'm following a youtube video that shows how to put a small electrical box on the roof to cover the pvc hole and run the antenna cable out the electrical box for full waterproof but always have access to just slide another wire up through the pvc and out to the roof. Going to cut it in the location you and I talked about and mount my 4x4 mimo at the roof peak and use a metal extender to get it higher in the air. That should be by last big project for the summer. Before we go to florida I'm going to attempt the sewer mod where I run everything to the single drain. My buddy is a master plumber and will help me with that. After that all these projects will be done and I can just sit back and enjoy the ride, hopefully, lol.

[WhittleBurner]

We had the pleasure of replacing the old kan(t) leak panel with a new kan(t) leak panel that we have had stashed away since the 2nd rally. Also a new quiet water pump. Tomorrow we pack to go away for the week on Monday.

[A.Texas.Yankee]

Finally got some other cameras in. Need to figure out how mount one for on box area. But I get 4 corner coverage now so it's not too high on my list. Getting one into the wet bay is higher.

Full-time Traveling Family ,'21 Momentum 395MS-R, '21 F450 King, 2000watts solar, Dual Victron MP-II 12/3000 2 x 120v, DIY 15kwh LiFePo4 battery with Daly BMS
Attachment 41197