User Tag List
Thanks: 0
Results 11 to 18 of 18
-
05-06-2023, 04:18 PM #11
- Join Date
- Apr 2020
- Location
- Colorado
- Posts
- 40
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Greg & Vicki
US ARMY Retired
2020 F250 Platinum 6.7L Diesel 10 Speed 4x4
2020 Imagine 2450RL
ProPride 3P hitch
-
05-06-2023, 08:26 PM #12
- Join Date
- Oct 2017
- Location
- Round Rock, Texas
- Posts
- 360
- Mentioned
- 2 Post(s)
- Tagged
- 0 Thread(s)
Our 2017 2600RB was recently leaking in the wet bay. Last time is was the city connection, this time it was the valve. https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
As per a prior recommendation, I replaced the side panel with plexiglass. I'm getting a lot better with PEX crimps in tight places.Jeff and Mary
2017 2600RB
2022 F250 Lariat CC 6.7 w/ Max Tow
Round Rock, (Donut Capital of Texas) <><
-
05-07-2023, 08:42 AM #13
- Join Date
- Oct 2021
- Location
- Dry Ridge, Ky
- Posts
- 47
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
My 2600 RB had 2 leaks behind the panel also. One was just the hand tighten fitting on the outside spigot inlet to the hot water, easy fix, the other a pex clamp. As said before , plexiglass to replace the side panel ! I've laid a couple of paper towels down on the floor beneath all of the stuff so you can get a quick look anytime
2022 2600 RB , Road Armor + wet bolt and heavy shackle kit
2021 Ram 1500 Premier, 5.7 E Torque , 3.91 rear end, trailering kit
-
05-10-2023, 05:08 AM #14
- Join Date
- Dec 2020
- Location
- Alpharetta, GA
- Posts
- 123
- Mentioned
- 3 Post(s)
- Tagged
- 0 Thread(s)
Attachment 46250
FIXED ! ... but a lessoned learned.
The wet bay in the 22 MLE is oriented (North/South) in the garage. Removing the VERY small panel does NOT provide much room to do anything. I had to call in a mobile RV service tech (more about him later) as the dealership could not see me until mid-June.
The small access point did allow the service tech to see the issue - the city connection to the rig was just loose! According to the tech, these valves are prone to break if not winterized properly. Not to mention just the vibration from being on the road could have also caused this. So the problem was easily fixed, but getting to it was not easy. The service tech made it so I could access the back-side of the wet bay similar to the way I access the winter/dewinter valves under the sink. Instead of tacking and gluing the panel/molding back, he put in screws on the corners to secure the panel. The top molding was tacked down - easy to remove. Now I have an easy way to access the back of the wet bay. The mobile RV tech told me to check these and all other water connections inside the rig on regular basis. A good way to see (or hear) if there is a water leak issue, which may or may not be easy to spot, would be to run the internal water pump and listen if it cycles without you using any faucet.
I hope the monitors allow this, but too often people complain, and sometimes rightfully so, about mobile rv technicians. I did some research and found a fantastic mobile rv tech in the North Georgia area. Go here They are RVTAA Certified, Licensed, and Insured! Shane, the owner/tech was a pleasure to work with. VERY knowledgeable and helpful. I asked Shane to look at my roof and he gave me product information that he recommends that I do as a preventative measure. HIGHLY RECOMMEND !
Lastly, I am no longer renting a Tow Vehicle !!
Picked up a 2020 RAM 2500 diesel, named "Fiona" I will update my signature shortly.Mitch and Alisa Frank
2020 Imagine XLS 22 MLE
2020 RAM 2500 Diesel
-
05-10-2023, 06:56 AM #15
-
05-10-2023, 07:36 AM #16
- Join Date
- Dec 2020
- Location
- Alpharetta, GA
- Posts
- 123
- Mentioned
- 3 Post(s)
- Tagged
- 0 Thread(s)
Nice !
However, on the 22MLE, the side where you put your new opening, for me it is about 2 inches wide - useless.
To get the same access, I have to go through the coach next to the bed.Mitch and Alisa Frank
2020 Imagine XLS 22 MLE
2020 RAM 2500 Diesel
-
05-10-2023, 07:48 AM #17
-
05-10-2023, 09:08 PM #18
- Join Date
- Feb 2018
- Location
- SW Colorado
- Posts
- 2,696
- Mentioned
- 42 Post(s)
- Tagged
- 1 Thread(s)
Pull the false wall in the pass through - about 6 screws - it will give you access to the back of the panel and your water pump. Sounds to me like a simple loose fitting. Snug everything up and check.
Other place to look is the water pump intake filter bowl - check for a cracked dome
cover.
Good luck2018 Reflection 150 Series 220RK 5th wheel with 6K axle upgrade. B&W 25K OEM Companion, Steadyfast system, 2022 F350 SRW 6.7 King Ranch 8' bed, Trailer reverse lights, rear spare tire holder, storage tube, sumo springs, Victron MultiPlus 12/120/3000, and Solar
Stupid question, do I need to...
Today, 01:39 PM in New To RV'ing, Purchase Questions & General Concerns