User Tag List
Results 1 to 10 of 14
Thread: leveling system
-
08-13-2018, 11:58 AM #1
- Join Date
- Feb 2016
- Location
- Pennsylvania
- Posts
- 13
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
leveling system
I have a 2015 303rls fifthwheel and I keep getting an error on the leveling system when trying to level. Keeps telling me there is an error with the left front level jack. It tell me to hit enter to clear error but it does not clear it. What should I do to clear the error.
-
08-13-2018, 12:09 PM #2
Ramman2500 - I have tagged Emily Stahley (Grand Design representative) to your post. In the mean time, you can try calling for assistance at the following numbers:
Lippert - 574-537-8900
Grand Design Customer Service: 574-825-8900
When you call, have your VIN handy along with the type of leveling system you have.
Jim
-
08-13-2018, 01:40 PM #3
- Join Date
- Oct 2017
- Location
- Massachusetts
- Posts
- 280
- Mentioned
- 3 Post(s)
- Tagged
- 0 Thread(s)
Had the same issue, believe it was due to a battery issue ie had disconnect off, if you are able to drop the jacks at least 6 inches, so that all jacks are then retracted at least 6 inches to full retract it can be cleared. It’s in the lippert manual . The error messages were confusing.
Sent from my iPad using Tapatalk2018 Reflection 27RL
2017 GMC 2500
-
08-14-2018, 06:40 AM #4
- Join Date
- Sep 2016
- Location
- Indiana
- Posts
- 213
- Mentioned
- 13 Post(s)
- Tagged
- 46 Thread(s)
Good morning!
When you get an individual jack error that means that motor has lost count of the other motors. All the motors on this system work together, through a hall effect signal. In order to clear the error you will need to run the jacks down manually (you can do this in manual mode) to at least 4-6" from full retract. Then you will press and hold the retract button until the motors start to run and raise all the jacks up. It will look scary because it will lower the nose of your coach to the ground, or to where your drop legs are extended. Be sure to bring up your step and remove anything from under your nose, or coach so nothing gets damaged.
Once it does that it will say ready jacks up. You can then run the front jacks down so your nose is high, and then you can press auto level!
IF YOU HAVE 6 JACKS INSTEAD OF 4...... to run the center jacks down manually you press the left and right buttons at the same time and it will drop the center jacks. Be sure those are run down 4-6" as well before hitting retract. This is the ONLY time you will be able to operate the center jacks manually
Hope this helps!
Emily
-
08-14-2018, 09:18 AM #5
-
08-14-2018, 07:35 PM #6
- Join Date
- Sep 2016
- Location
- Indiana
- Posts
- 213
- Mentioned
- 13 Post(s)
- Tagged
- 46 Thread(s)
-
08-23-2018, 09:32 PM #7
- Join Date
- Apr 2018
- Location
- Houston, TX
- Posts
- 18
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Thank you for the instructions, Emily! Can we do this while hitched up? It would seem to be safer that way so the nose doesn't go so far down. We did our shake down cruise a couple of weekends ago and had this issue, so we need to fix it as well.
Alan & Helen Buckner
Houston, Texas - Weekenders now; full timers in 3 years!
2019 Reflection 337RLS with Reese Goosebox and Champion 3400W Generator
2017 Ford F350 Lariat Diesel 4x4 SRW with B&W Turnoverball Hitch + 4" extender
-
08-24-2018, 02:18 AM #8
-
08-24-2018, 04:59 AM #9
- Join Date
- Oct 2017
- Location
- Massachusetts
- Posts
- 280
- Mentioned
- 3 Post(s)
- Tagged
- 0 Thread(s)
It can work while hitched, as long as the jacks can travel > 6 inches. Don't need to worry about dipping to low though as long as the truck is clear!
2018 Reflection 27RL
2017 GMC 2500
-
08-24-2018, 08:21 AM #10
- Join Date
- Sep 2016
- Location
- Indiana
- Posts
- 213
- Mentioned
- 13 Post(s)
- Tagged
- 46 Thread(s)
Freezer Opens on Travel Day?
Today, 03:46 PM in Appliances