SilentService

Yep, same with me! Been sitting on my three since I had to replace the first one and it's been over 5 years. The way I look at it, not...

I carry a lot of spare parts with us but this is one I didn't have. Yup I'll get another as a spare. When you need it and don't have...

https://www.amazon.com/SEA-FLO-51S01-Strainer-10-Pack/dp/B08WM3VHMD/ref=sr_1_3?crid=3HAFVSKW1QEQH&dib=eyJ2IjoiMSJ9.et0kdsVoHkPb8NtzwBjqVG...

I had this happen years ago but caught it early. Since then, I've had three extra filter replacements in reserve for an easy repair...

Typically your shower water will go to your gray tank which, for your trailer, has a capacity of 82 gallons. Not sure why your black...

Remove the vent cover on the roof and pour a pitcher of water down. If it makes it to the tank, you don't have a clog. More likely you...

If I read your post correctly, Dicor sealant or a strip of Eternabond tape. Just makes sure you first clean the area very well.

When ours is not in use, I usually leave the kitchen slide out, the living area and bedroom slides in. This way I can go in and still do...

We have a friend who bought a 3D printed mount that they fastened to the roof of their RV. They next cut off the back of the Gen2 dish...

You are probably correct on where it is coming in. I would also inspect where the cap meets the roof on top to see if the Dicor sealant...

Correct. You can get the equipment first then activate your service when you are ready.

So far it has ran very well. The outer plastic case does get a little hot. I may end up mounting it on two slats of wood to allow the...

So here is my question for those that have a gen2 dish. How does one mount it on top pf the RV for in motion?

FYI, the Gen3 does not have an internal motor. My bad!

It will work in motion. Iwas was unaware it didn't have the internal motor like the Gen2 so I'm not sure what your app will look like.