2025 Reflection 315: Do Rear Jacks Adjust With the Front?

Thread Summary

Summarized on:
Original Member Title: Question about the electric jacks on a 2025 Reflection 315
This AI-generated summary may contain inaccuracies. Please refer to the full thread for complete details.
A member asked whether the electric leveling system automatically adjusts the rear jacks when the front is raised manually, to avoid stressing the camper. Auto-level sometimes left the front low, and the member later reported a driver-side lean and a sticking door after manual leveling. One member said the system does not automatically compensate during manual adjustments and recommended recalibrating the auto-level position using the manual’s procedure.

Members suggested checking...
More...

el Rojo

Senior Member
Joined
Aug 28, 2013
Posts
2,434
Sometimes when we hit auto level the front of the camper is a little low. The question is, if I raise the front of the camper, is the jack system smart enough to raise the rear jacks at the same time to compensate for the new angle and not put "U" shaped stress on the camper?

Red
 
Not sure about electric jacks, but hydraulic jacks won’t do that. It’s either auto or manual leveling. Not a combo of both. Get a 4 point level and just level it manually. That’s what I did with our fiver. I didn’t like the “dance” it did on auto. Only added a few minutes to setup.
 
Sometimes when we hit auto level the front of the camper is a little low. The question is, if I raise the front of the camper, is the jack system smart enough to raise the rear jacks at the same time to compensate for the new angle and not put "U" shaped stress on the camper?

Red
No, it is not smart enough. You need to recalibrate the auto level position in the system so that when you use the auto level, it will level properly. Otherwise, go to manual and level it yourself.

The auto level uses a small box that is located under the trailer, usually in the rear. The user can set what is level, and as you have found out, it isn't a one time set and forget. The manual has the procedure to re-set the level, and is easy to do.
 
In the current spot I'm in, when I auto level the nose is low and leaning to the drivers side. After I use the manual function and level the trailer the door sticks.
Ant ideas on how to resolve this issue?
 
A Level. I also walk inside.
I have both a small and 2' level that I use. You can get several different measurements depending on where in the trailer you are at. Counter tops are not always the same as the floor. Also, in the manual mode, mine shows the tilt of the trailer, and I can adjust it using that, and verifying with the level.

Using the level on the door frame, does the door still stick?
 
El Rojo, I used to have a sticky door at times after using the auto-level. I ended up using auto-level, then went to manual level and played with the system until the door quit sticking and found one of the sides was about .01 out of level. Not much off but just enough. I reset the auto-level at that point and have had not problems since.
 
El Rojo, I used to have a sticky door at times after using the auto-level. I ended up using auto-level, then went to manual level and played with the system until the door quit sticking and found one of the sides was about .01 out of level. Not much off but just enough. I reset the auto-level at that point and have had not problems since.
Thanks for your response. I'll try that.
 

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top Bottom