Coroplast Patch?

[Rovers]

Hi all.

While replacing the equalizers on my Imagine 2400BH I accidentally created a 3 inch long by 1 inch wide hole in the coroplast right up against the frame rail. I'd like to patch it mainly to insure rodents don't use it as the doorway into the rig - with the suspension as the escalator.

Is there a recommended means to patch the hole? Heavy duty gorilla tape? EternaBond tape? More coroplast?

TIA!


Bob

 

[NB Canada]

I would just use gorilla tape


2021 Imagine 2400 BH
2018 GMC Sierra 4x4 crew

 

[Hitsman3]

This is what I used when i just recently installed the Steadyfast system on our trailer & had to cut a few holes along the edge. Scrim tape from amazon. Also used foam spray, the kind for ponds.
https://www.amazon.com/Surface-Shie...d=1&keywords=scrim+tape&qid=1619621845&sr=8-2

 

[Justa5th]

This is what I used when i just recently installed the Steadyfast system on our trailer & had to cut a few holes along the edge. Scrim tape from amazon. Also used foam spray, the kind for ponds.
https://www.amazon.com/Surface-Shie...d=1&keywords=scrim+tape&qid=1619621845&sr=8-2

This ^ is the appropriate tape.

 

[Rovers]

This is what I used when i just recently installed the Steadyfast system on our trailer & had to cut a few holes along the edge. Scrim tape from amazon. Also used foam spray, the kind for ponds.
https://www.amazon.com/Surface-Shie...d=1&keywords=scrim+tape&qid=1619621845&sr=8-2

This ^ is the appropriate tape.

I'd never seen this tape until now - just bought a roll.

Thanks so much!


Bob

 

[Justa5th]

Clean the surface well before applying ( I believe I used rubbing alcohol). Use a hair dryer or heat gun on low to just warm the tape after you apply it. It is fairly difficult to remove so make sure you get it in the correct place.