Imagine 2600RB Furnace Temperature Sensor Workaround

Dale Bradford

New Member
Joined
Oct 4, 2026
Posts
3
Location
Ontario Canada
GD Imagine 2600RB

Furnace does not operate correctly unless the a/c cover and filter is removed. The room sensor is in the a/c unit. Does anyone have a work around?
 
Take the filter out, you'll find a short black wire that is the thermocouple sensor for temperature. Poke it through the filter then reinstall. Some people go to the effort of getting a longer sensor and wire it near the thermostat, I never felt that was necessary.
20261014_164820.jpg
 
Since in their infinite wisdom, GD put the temperature sensor in the return air box of the a/c, the heater cannot see temperatures below that level. This has been covered many times in this forum. On my 2600 they used 7 wire thermostat wire so there was ample wire to put the sensor over above the controller. I just cut the sensor wires off and hooked them up to a couple of the unused wires running across the room. Fish the extra wires of the same color a couple of inches up, hook up thre sensor and mount on the wall. This was a kit I found years ago on Amazon for wall mounting. My whole system now works like it should with just an hours worth of work . I hope they used thermostat wire with extras or else the fish across the room could be a mess because of insulation in the ceiling. Good luck
 

Attachments

  • camper thermostat (1).jpg
    camper thermostat (1).jpg
    178 KB · Views: 30
GD Imagine 2600RB

Furnace does not operate correctly unless the a/c cover and filter is removed. The room sensor is in the a/c unit. Does anyone have a work around?
We have a 2024 GD 303, now the wall thermostats work for the furnace. As the thermostat probe is on the bottom of the wall thermostat, but it is not for the A/c.

The thermistor for the a/c is located in the duct area of the a/c unit, which gives false readings and shuts down before reaching temperature in the room.
I have contacted Grand design about this poor design. This past summer I contacted them and was told that LIppert admitted to it, and now have an upgrade to correct the problem.

I contacted the dealer where we bought the unit and will be going in 2 weeks to get the upgrade on the a/c units....sticking the thermistor through the filter is a band aide approach. It helps some but not much
 

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top Bottom