Roaming Investors
New Member
- Joined
- Sep 9, 2021
- Messages
- 1
My ramp door on my 2018 397TH Toy Hauler has separated at the corner of the frame, and I cant close the gap.
Experimenting, I can open the gap further and tap it back, but it won't close.
If I grab the compression latch and push/pull the side frame moves in and out. (See the caulk/paint line gap difference in the pictures)
I can make the gap wider in the corner to see how it moves, but when I try to tap it back with a mallet it won't close any further than it it now.
Is the wall/ramp panel inside the frame not actually attached to the frame? I see no screws going into it.
If so I could take the top frame off and maybe tap the panel down further and re-caulk.
One side of the "corner bracket" inside the frame isnt glued anymore, but I cant close the gap.
I'm just trying to make the frame closed all around and re-caulk.
Anyone have experience with this? Lippert says replace entire door. (not going to happen)




Experimenting, I can open the gap further and tap it back, but it won't close.
If I grab the compression latch and push/pull the side frame moves in and out. (See the caulk/paint line gap difference in the pictures)
I can make the gap wider in the corner to see how it moves, but when I try to tap it back with a mallet it won't close any further than it it now.
Is the wall/ramp panel inside the frame not actually attached to the frame? I see no screws going into it.
If so I could take the top frame off and maybe tap the panel down further and re-caulk.
One side of the "corner bracket" inside the frame isnt glued anymore, but I cant close the gap.
I'm just trying to make the frame closed all around and re-caulk.
Anyone have experience with this? Lippert says replace entire door. (not going to happen)



