2018 Reflection 303 RLS, dinette side, 2x2 through the frame slide. Long time issue. Closed to ½ way out, normal condition, then loud ear piercing metal on metal sound to full open, then loud ear piercing metal on metal sound to ½ way in, then normal sound to full in.
I did LIP 0065, the 5/16” washer fix on the wear tabs.
The Lippert slide video, https://youtu.be/X1A2q55BfLs shows, step 1-measuring from top of outer tube as close to the I Beam as possible to the room floor, step 2-measure the inner arm to room floor, adjust to within ¼ inch.
I hope this makes sense! My slide outer tubes stop under the fixed floor well before the slide room floor so I can’t measure outer tubes to slide room floor. (See Pic 1) So my step 1 is to measure from the inner arm to bottom of slide room floor. That measurement is 4-9/16” (See pic 2) at about 6” from the end of outer tube.
In step 2, I can measure the outside end of the inner arm to room floor. That measurement is 5-1/16” or 1/2” difference. I would think since I am measuring the inner arm on both ends it should be the same distance, CORRECT? So, I would need to adjust and lower the outside end of slide room the full 1/2”?
Now the real problem, the outside end of the slide room that needs to be lowered, however, it is already at its lowest adjustment (See pic 4) and the head assembly bolts have no more adjustment available. Any Ideas? Thank you.
I did LIP 0065, the 5/16” washer fix on the wear tabs.
The Lippert slide video, https://youtu.be/X1A2q55BfLs shows, step 1-measuring from top of outer tube as close to the I Beam as possible to the room floor, step 2-measure the inner arm to room floor, adjust to within ¼ inch.
I hope this makes sense! My slide outer tubes stop under the fixed floor well before the slide room floor so I can’t measure outer tubes to slide room floor. (See Pic 1) So my step 1 is to measure from the inner arm to bottom of slide room floor. That measurement is 4-9/16” (See pic 2) at about 6” from the end of outer tube.
In step 2, I can measure the outside end of the inner arm to room floor. That measurement is 5-1/16” or 1/2” difference. I would think since I am measuring the inner arm on both ends it should be the same distance, CORRECT? So, I would need to adjust and lower the outside end of slide room the full 1/2”?
Now the real problem, the outside end of the slide room that needs to be lowered, however, it is already at its lowest adjustment (See pic 4) and the head assembly bolts have no more adjustment available. Any Ideas? Thank you.
