Thermostat reading

[redram]

My thermostat will not read room temp. only set point. Any ideas. 2014 Reflection 303 It has the Atwood air command. Don

 

[TucsonJim]

Try shutting down the rig by removing shore power, then toggling the battery disconnect switch, then turn the battery back on and try again.

 

[2hams]

We have an indoor/outdoor thermometer. It shows both indoor and outdoor temps. We set it on the hutch countertop and hang the outdoor sensor off the kingpin.

Great camping toy to see high and low temps.

 

[huntr70]

The Atwood is the brand new A/C system used in the Reflection.

I haven't played with one long enough to know if it will display inside temp or not. Do you have the owners manual for it?

 

[CentralMichBo]

I think after you adjust your set point, the thermostat is supposed to go to room temp after 5 seconds. Now you have me wondering, I'll have to go out and see.

 

[redram]

I did not get the instructions with it. I went online and got them. It is supposed to read room temp after you set your temp. Don

 

[CentralMichBo]

I found my instructions in with the furnace manual.

 

[GDRV Service]

My thermostat will not read room temp. only set point. Any ideas. 2014 Reflection 303 It has the Atwood air command. Don

Hi @redram,

Press and hold the "sleep" button for 3 - 5 seconds to display the room temperature.

The display will go back to the set temperature after releasing the button.

Best regards,
~ Janice.

 

[redram]

Thanks very much Janice. That worked. I don't know how we are supposed to know that.